Comments: The Pursuit of Nuclear Energy in Bangladesh - Facts and Figures to Consider By Habib Siddiqui

According to a published news report, the Government of Bangladesh is aggressively targeting to set up at least a 1000 MW nuclear power plant in the country within a decade. The official sources say that currently the Bangladesh government has received three preliminary proposals from Russia, China and South Korea.
The news should come as no surprise given the current government’s promise and commitment to mitigate the appalling energy shortage inside the country. With all the added emphasis on limiting harmful greenhouse effects, it is safe to assume that nuclear energy remains a viable option to meeting Bangladesh’s growing energy needs. It has no “carbon footing” and does not cause climate change. On the other hand, its disadvantages involve the unsafe nature of the process and the exhaustibility of its fuel, e.g., uranium for thermal fission reactors and plutonium for breeder reactors (note: the latter material can be used directly to making “dirty” bombs, while the former requires sophisticated concentration before it can be used in a weapon).
As Bangladesh explores her nuclear option, it is important that we have a good understanding of this technology. The processes used in nuclear power industry start with mining. The basic ingredient is uranium which has the advantage of being an enormous source of energy, and it is easily and cheaply transportable. It exists in nature in three isotopes: U-238 (99.284%), U-235 (0.711%) and U-234 (0.005%). The uranium content is referred to as triuranium octaoxide, U3O8., which is the most common (and stable) form found in nature. Uranium dioxide, UO2, is the form in which uranium is most commonly used as a nuclear reactor fuel. At ambient temperatures, UO2 will gradually convert to U3O8.
Currently, the fuel price of U3O8 is around $50/lb. It is highly likely that the price would reach $100/lb with growing demands, which would inevitably trigger more exploration of mines and their profitable recovery. Experts estimate that the global reserve is around 4-5 million tons. At current global consumption of approximately 77,000 tons/year, this reserve will last only for 65 years. This reserves-to-production (R/P) ratio of 65 is well below coal and only 50% more than oil or natural gas.
Today, nuclear energy supplies only 7.5% of the total global energy consumption, corresponding to 17% of the global electricity consumption. With growing concerns on carbon emission, it is safe to assume that this percentage will grow in coming decades. Unlike fossil fuel based energy options, the nuclear industry is only 55 years old with the first plant built in 1954 in the USSR. Since then, some 575 nuclear power plants have been built around the globe, including 125 in the USA. As of 2008, the installed capacity of all the running plants in the world is 413 GW of which 119 GW is in the USA. The actual electric production, however, is only about 300 GW (and approx. 100 GW in the USA) giving an asset utilization of 73% globally (and 84% for the USA). Of all those plants built since 1954, 439 are still operating, 119 have been shut down. However, since decommissioning of nuclear plants is a highly complicated and expensive process, only 17 (of those 119) plants have really been decommissioned. According to an industry expert, Bela Liptak, three nuclear plants were started in 2007, and currently another 35 are under construction (The Future of Nuclear Energy, Control Magazine, March 2009).
In the USA, in the post-Three Mile Island (TMI-2) nuclear accident (1979) period, because of mounting concerns on safety of operation, risk to living beings plus hazards related to safe disposal of nuclear waste, all applications to build nuclear plants were turned down. Of the already built plants, 13 have been permanently shut down, and 10 have completed their decommissioning. Even after all these years, most Americans don’t favor having a nuclear plant built in their neighborhoods.
The total investment to build an average power nuclear plant is estimated to be over $4 billion. (The typical life of a nuclear power plant is 30 to 60 years.) In spite of such high capital costs (and the need to internalize all waste disposal and decommissioning costs), nuclear energy is, in many places, competitive with fossil fuel for electricity generation. If the social, health and environmental costs of fossil fuels are also taken into account, nuclear is outstanding. In this regard, the 2001 report of a major European study of the external costs of various fuel cycles, focusing on coal and nuclear, ExternE, is quite revealing. It shows that in clear cash terms nuclear energy incurs about one tenth of the costs of coal. The external costs are defined as those actually incurred in relation to health and the environment and quantifiable but not built into the cost of the electricity. If these costs were in fact included, the EU price of electricity from coal would double and that from gas would increase 30%. These are without attempting to include global warming. Nuclear energy averages 0.4 euro cents/kWh, much the same as hydro, coal is over 4.0 cents (4.1-7.3), gas ranges 1.3-2.3 cents and only wind shows up better than nuclear, at 0.1-0.2 cents/kWh average. (Note: these are the external costs only.)
As to the overall breakdown of fuel cost, it is worth noting that uranium has to be processed, enriched and fabricated into fuel elements, and about half of the cost is due to enrichment and fabrication. A January 2007 analysis shows that to make 1 kg of Uranium as UO2 reactor fuel, the cost of 8.9 kg of U3O8 is (USD) $472 (@ $53/kg), the conversion cost for processing 7.5 kg of U (@ $12/kg) is $90, the enrichment cost is $985 and fabrication cost is $240. That is, the total cost for 1 kg of Uranium as UO2 reactor fuel is $ 1787. At 360,000 kWh of electrical power per kg, this translates into 0.50 cents/kWh. Now if we assume a 100% increase in U3O8 price, while other costs (processing, enrichment, fabrication) remain the same, the total cost will be $2286, i.e., only a 28% increase in overall price to 0.635 cents/kWh. Even when the costs for radioactive spent fuel and the ultimate disposal of this spent fuel or the wastes separated from it are factored in, the total fuel costs of a nuclear power plant in the OECD are typically about a third of those for a coal-fired plant and between a quarter and a fifth of those for a gas combined-cycle plant.
Fuel costs are one area of steadily increasing efficiency and cost reduction programs. For instance, in Spain nuclear electricity cost was reduced by 29% over 1995-2001. This involved boosting enrichment levels and burn-up to achieve 40% fuel cost reduction. Prospectively, a further 8% increase in burn-up will give another 5% reduction in fuel cost.
For nuclear power plants any cost figure normally includes spent fuel management, plant decommissioning and final waste disposal. Decommissioning costs are about 9-15% of the initial capital cost of a nuclear power plant. The back-end of the fuel cycle, including used fuel storage or disposal in a waste repository, contributes up to another 10% to the overall costs per kWh, - less if there is direct disposal of used fuel rather than reprocessing.
The US cost figures for 2007 published by the Energy Utility Cost Group showed nuclear utility generating costs averaging 2.866 c/kWh, comprising 1.832 c/kWh for operation and maintenance, 0.449 c/kWh for fuel and 0.585 c/kWh for capital expenditure. An EU 2007 study, on the other hand, compared electricity cost (US cents/kWh): 5.4-7.4 for nuclear, 4.7-6.1 for coal, 4.6-6.1 for gas, 4.7-14.8 for wind in-shore, and 8.2-20.2 for wind off-shore. In January 2009, CEZ published cost for new nuclear plants at 6 euro cents/kWh (comprising of 3.8 cents for capital, 1.0 for fixed cost and 1.2 for fuel cost). Nuclear power is very capital-intensive, while fuel costs are relatively much more significant for systems based on fossil fuels.
Any capital cost figure from a nuclear reactor vendor, or which is general and not site-specific, will usually just be for EPC (engineering, procurement and construction) costs. This is because owner's costs will vary depending on whether a plant is new or at an established site, perhaps replacing an old plant.
Long construction periods will push up financing costs, and in the past they have done so dramatically. It used to take eight to ten years to set up a 600-1000 MW power plant in most countries, as it required fulfilling many conditions for a safe and regulated nuclear plant. In Asia construction times have tended to be shorter. For instance, the new-generation 1300 MWe Japanese reactors which began operating in 1996 and 1997 were built in a little over four years, and 48 to 54 months is typical projection for plants today.
As hinted earlier, in terms of energy generation, one kg of natural uranium is equivalent to 20,000 kg of coal. The fuel's contribution to the overall cost of the electricity produced is relatively small, so even a large fuel price escalation will have relatively little effect. For instance, typically a doubling of the uranium market price would increase the fuel cost for a light water reactor by 28% and the electricity cost about 7%, whereas doubling the gas price would typically add 70% to the price of electricity from that source. (This fact is especially important for countries like Bangladesh in coming years with ever declining supply of oil and gas.) There are other possible savings from nuclear fuel. For example, if spent fuel is reprocessed and the recovered plutonium and uranium is used in mixed oxide (MOX) fuel, more energy can be extracted. The costs of achieving this are large, but are offset by MOX fuel not needing enrichment and particularly by the smaller amount of high-level wastes produced at the end.
The safety record of mining, enrichment and fuel fabrication is fairly good. While nuclear fuel preparation is relatively safe, it is not accident-free. Most nuclear accidents occur in the nuclear reactors themselves. The majority of these accidents are caused by design or operator errors involving either the coolant controls or the fuel rod. Radiation leaks can also occur because of earthquakes, poor waste storage practices, ageing or terrorist attacks. The most important goal is to maintain standard operation of the reactor cooling system. Run-away reactions can evolve too quickly, while plant shut down is slow and complicated. Thus, having backup controls and equipment is more important than in other industrial operations.
As Bangladesh evaluates vendor information on nuclear power plants, it is important that her decision makers are fully cognizant of this technology so that the best possible deal can be sealed that protects the interest of our people.
[About the author: Dr. Siddiqui studied the counter-current flow limitation phenomena during a loss-of-coolant-accident in a nuclear power plant as part of his graduate research work in nuclear engineering in the early 1980s in the University of California. He can be reached at saeva@aol.com.]

Our Mission

Bangladesh Expatriate Council (BEC) is a non-political and non-partisan organization, made up of expatriates from Bangladesh who care deeply about Bangladesh by becoming active citizens in their respective adopted countries for the purpose of guaranteeing that their voices and concerns are heard and acted upon by governments. Its main purpose is to work as an advocacy group for its expatriate community. It is run by the expatriates and for the interest of the expatriates.
• Its aim is not to divide but to strengthen the expatriate community.
• Its aim is to make a better Bangladesh that we all can feel proud of.
As such, we work together with people of all religions and ethnicities, as well as with other citizens of the world who agree with our mission and with our ideals.
Today, Bangladeshi Expatriates need to play an active role not just where they are currently settled as citizens but also in Bangladesh. If we are going to be able to change policy and influence decisions that affect our people, it is imperative that we cooperate with each other on commonalities that tie us together.
We are driven by the belief that Bangladesh expects better from its talented and highly skilled expatriate community that has settled in various parts of our planet.
We have a right and a responsibility to be involved in the world around us, especially matters that happen in Bangladesh. We simply cannot shut our eyes to what happens in Bangladesh. That involvement includes community, social and political action (without being looked upon as being partisans).

What we care about?

We are expatriates from Bangladesh who now live outside the country. Many of us are now settled in the USA. We are engaged in various professions. We care very deeply about Bangladesh and would like to see good for people living there. We are willing to cooperate with anyone interested in helping Bangladesh.

Aims and purpose of the Bangladesh Expatriate Council

Its main purpose is to work as an advocacy group for its expatriate community. It is run by the expatriates and for the interest of the expatriates. Its aim is to make a better Bangladesh that we all can feel proud of. As such, we work together with people of all religions and ethnic backgrounds, as well as with other citizens of the world who agree with our mission and with our ideals.
Today, Bangladeshi Expatriates need to play an active role not just where they are currently settled as citizens but also in Bangladesh. If we are going to be able to change policy and influence decisions that affect our people, it is imperative that we cooperate with each other on commonalities that tie us together. We are driven by the belief that Bangladesh expects better from its talented and highly skilled expatriate community that has settled in various parts of our planet. We have a right and a responsibility to be involved in the world around us, especially matters that happen in Bangladesh. We simply cannot shut our eyes to what happens in Bangladesh. That involvement includes community, social and political action (without being looked upon as being partisans). Effective citizen activism begins with the knowledge that Bangladesh is in a dire state of its existence and needs improvement at every stratum – governmental and non-governmental - to break down its vicious cycle of corruption, violence, incompetence, cronyism, patronage, and complexities of politics. Such activism also includes conveying those issues clearly that are important to our community. BEC works at providing critical education and information to the expatriate community in order to advocate for causes that matter, and challenge and equip individuals and sister/brother organizations to make a difference at all levels of government and non-government organizational (NGO) activities. To that end, we continuously work to identify, educate and mobilize our expatriate community for effective political action! Such actions will preserve, protect and defend our humane values that define our humanity, and hopefully make our planet a better place to share for our posterity.